Rear Panel (Connecting Your Equipment) - Roland JUPITER-X Reference Manual

Panel Descriptions
Rear Panel
(Connecting Your Equipment)
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
E
CTRL jack
F HOLD jack
Expression pedal (EV-5)
Pedal switch (DP series)
B
D
MIDI port
Connect MIDI devices.
B AC-IN jack
Connect the included power cord here.
C
[L] switch
This turns the power on/off (p. 11).
D
MIDI (OUT/IN) ports
Transmit or receive MIDI messages to or from an external MIDI
device connected here.
E
CTRL jack
Connect an expression pedal (EV-5; sold separately).
* Use only the specified expression pedal. By connecting any other
expression pedals, you risk causing malfunction and/or damage to the
unit.
F
HOLD jack
Connect a pedal switch (DP series; sold separately).
G AUX IN jack
Connect an external audio device.
Use a stereo mini plug for this connection.
H
MIC
[MIC GAIN] knob
Adjusts the volume of the mic input.
MIC IN jack
Connect a dynamic
microphone or electret
condenser microphone
(plug-in power system)
here.
* A condenser microphone (phantom powered) cannot be used.
I
OUTPUT L/R jacks
These are output jacks for audio signals.
8
G
AUX IN jack
Connect an audio device.
or
C
H
MIC
Dynamic microphone Electret microphone
(mono)
Pin assignment of MIC IN jack
※ 入力端子の場合
TIP: HOT
2: HOT
RING: COLD
SLEEVE: GND
3: COLD
J
OUTPUT (BALANCED) jacks
M
I
OUTPUT jack
Monitor speaker
(Amplifier built-in)
J OUTPUT (BALANCED) L/R jacks
These are output jacks
※ 入力端子の場合
for audio signals.
TIP: HOT
2: HOT
RING: COLD
SLEEVE: GND
K
PHONES jack
3: COLD
You can connect a set of headphones here.
L USB port
USB MEMORY port
You can connect a USB flash drive here.
Connect or disconnect the USB flash drive while the JUPITER-X
is powered-off.
* Never turn off the power or disconnect the USB flash drive during a
process, such as while the
USB COMPUTER port
Use a USB cable to connect this port to a USB port of your
computer.
This allows the JUPITER-X to operate as a USB MIDI device.
M
Ground terminal
* Connect this to an external earth or ground if necessary.
※ 出力端子の場合
1: GND 1: GND 2: HOT
3: COLD
K
Mixer
L
USB port
USB flash drive
Pin assignment of OUTPUT (BALANCED) L/R jacks
※ 出力端子の場合
1: GND 1: GND 2: HOT
3: COLD
"Executing..." display is shown.
PHONES jack
Headphones
Computer