Mcr Iii Tool Lab - GE OPTIMA MR360 Service Training

GE Healthcare

13. MCR III Tool Lab

Description:
Time Required:
Learning
Objective(s):
Support Materials
Required:
Tools Required:
Safety
Considerations:
Steps:
Questions:
Review:
MR5047 SV
This lab will familiarize the student with the MCR3 tool hardware setup
for Port A and Express PA coil, and software usage.
1 Hour
Navigate the service documentation

Set up the hardware connection for Port A and Express PA coil

Know how to run the software and read the test result

Service Methods procedures 5364191 on disk, or as loaded onto
system computer. Refer to MCR III Tool for MR355/360.
(http://3.28.123.26:8000/mr/cdrom/5364191-
2EN/root/data/Signa_EXCITE/content/1084956.htm)
MCR III Tool

Express PA Coil RF Cable Assy for MCR III Tool

Express PA Coil DC Cable Assy for MCR III Tool

Strong Magnetic Field! Ferrous materials can become dangerous
projectiles in the presence of the magnetic field Produced by the
Signa Magnet. Do not Bring any ferromagnetic tools or equipment
into the magnet room.
1. MCR III Diagnostic
Use documented procedure in Direction 5364191:
Troubleshooting / Image Quality Troubleshooting Tools / MCR
III Tool for Optima MR360 / Brivo MR355
a. Perform Port A, Express PA coil test
1. What is the function of the two-pin connector?
__________________________________________________
Questions for instructor:
______________________________________________________
______________________________________________________
______________________________________________________
Lab Guide
Page: 23 of 24