GE OPTIMA MR360 Service Training page 212

GE Healthcare
Questions:
Review:
MR5047 SV
f. Install the SF checker to J3 on the cabinet monitor. Observe
what will happen
g. Remove the SF checker and restore connector J3
h. Simulate leakage on the Leak Sensors3. Observe what will
happen and record the error message
i. Simulate leakage on the Leak Sensor2. Observe what will happen
and record the error message.
1. Is there any difference of the diagnostic result between step 1.a
and step1.b? How to explain it?
__________________________________________________________
2. What kind of switch is the sensor of water flow?
__________________________________________________________
3. How the cabinet monitor identifies three status of leak sensor:
Disconnected, normal and leakage detected?
__________________________________________________________
Questions for instructor:
______________________________________________________
______________________________________________________
______________________________________________________
__________________________________________________________
Lab Guide
Page: 18 of 24