Can Link Lab - GE OPTIMA MR360 Service Training

GE Healthcare

3. CAN link Lab

Description:
Time Required:
Learning
Objective(s):
Support Materials
Required:
Tools Required:
Safety
Considerations:
Steps:
MR5047 SV
This lab will familiarize the student with the CAN Link Diagnostic
1 Hour
Navigate the service documentation

Understand how the CAN Link works in SV system

Perform the CAN Link diagnostic and issue isolation procedure

Service Methods procedures – 5364191 on disk, or as loaded onto
system computer. Refer to CAN Link Diagnostic procedure.
(http://3.28.123.26:8000/mr/cdrom/5364191-
2EN/root/data/Signa_EXCITE/content/1084467.htm)
Standard hand tools
Follow all LOTO procedures. They are posted in the lab as well as
incorporated in the documented procedures
1. CAN Link Diagnostic
Use documented procedure in Direction 5364191:
Troubleshooting / Diagnostics / System Function / Patient
Handling / CAN Link Diagnostic
OR
Troubleshooting / Diagnostics / Hardware Location / Misc /
CAN Link Diagnostic
a. Perform CAN Link Diagnostic
2. Refer to the following CAN link diagram to perform the test:
a. Remove the terminator from cabinet monitor
b. Perform step 1 and record the test result
_______________________________________________________
c. Remove the connector J19 on the front panel of SRFD3 and
install the terminator on the front panel
d. Perform step 1 and record the test result
_______________________________________________________
d. Remove the connector J2 on the front panel of Driver Module
Lite and install the terminator on the front panel
e. Perform step 1 and record the test result
_______________________________________________________
f. Restore the connectors J2 on Driver Module Lite and terminator
on J11 of Cabinet Monitor
i. Remove connectors J18 and J19 from SRFD3, and connect them
together
Lab Guide
Page: 5 of 24