Table of Contents
Advertisement
Operation of the device, sensor system and apps
3.1.2
Fastening the carry strap to the SONOCHEK
Attaching the carry strap holder
The carry strap holder is pre-assembled. If this is not the case, proceed as follows:
Use the Allen key (supplied) to loosen the cylinder head bolt on the back of the SONOCHEK.
Attach the retaining lug with the supplied countersunk head screw (see the figure below) and
tighten it securely with the Allen key.
Attaching the carry strap
1. Loosen the end of the carry strap from the plastic adjustment buckle
2. Pull the adjustment buckle to a position in which the end of the carry strap is long enough for
attachment to the holder.
3. Place the carry strap on the red side so that you can see the backs of the adjustment
buckles.
4. Position the SONOCHEK so that the retaining lug points upwards and thread the tape from
the top downwards through the retaining lug.
5. Slide the end of the strap to secure it through both openings of the adjustment buckle,
tighten the end of the carry strap and measure the hold.
SONOCHEK 09.2018
Insufficient securing of the carry strap possible by using the wrong
screw!
Use the supplied countersunk head screw to secure the retaining lug.
SONOCHEK
27
Advertisement
Table of Contents
