Table of Contents
Advertisement
Operation of the device, sensor system and apps
The data is available on the end device in the drive folder SONOCHEK and can be selected
from there and copied.
3.8.3
Transfer measurement data to an external memory card
1. Insert the SD card (with the contacts facing down) into the provided slot at the bottom of the
device so that the card noticeably clicks into place in the slot.
The notification "SD card is being prepared" indicates that the card has been recognized by
the SONOCHEK. The status of the card can be accessed in the SONOCHEK settings.
2. Prepare the measurement data for export (see chapter 4.3). In the settings, select the check
box "External SD card," determine any folder name required and confirm the merging of the
data with "Create."
The setting is indicated by the notification "Write report" / "Export." The bar displays the
progress.
In order to remove the SD card from the SONOCHEK properly:
3. Wait until the data transfer is completed. This is indicated by a status message with the
specification of the data type and storage location.
4. In the overview, select
SONOCHEK 09.2018
Important!
Possible notifications from the system about the USB connection and about
the device driver software do not affect the functionality and can be
ignored.
Data loss and damage to the SD card possible!
In no case remove the SD card
while the data is being transferred and
before you have properly disconnected the memory card in the
SONOCHEK
settings.
"Settings"
Important!
Note that
the following menu item is only active if the device is not connected to a
computer via USB and
the internal SD card is also listed in the list of the memory, for which the
following described option is not available.
and then the menu item "Memory."
SONOCHEK
71
Advertisement
Table of Contents
