Table of Contents
Advertisement
SONOCHEK
4.2.4
Display of the temperature
The following information is relevant for the SONOLEVEL app.
Display the temperature in the range of the reading output:
1. Tap briefly on the panel in the reading output (see figure below) where the temperature is to
be displayed.
2. Select the value T to activate the display in the corresponding panel.
The application switches to live mode and shows the temperature (marked in yellow, see
figure below).
Show the temperature profile on the display:
1. Select
next page).
2. Activate the option "Display temperature profile" via check box.
3. Within the sensor measurement range from -94 °F to 716 °F (-70 °C to +380 °C), select a
range in which the temperature is to be shown on the display.
4. Tap on "Close" twice to return to the live mode.
The application shows the temperature profile as a yellow line parallel to the level profile.
4.2.5
Changing settings for temperature measurements
The following information is relevant for the SONOLEVEL app.
For correct temperature measurements, the correct emission ratio of the surface must be set
(also see chapter 3.5.9, description of the structure-borne sound sensor, temperature
measurements).
A material can be selected in the settings for which the associated emission ratio is stored.
Alternatively, a value can be manually set for the emission ratio.
Painted or oxidized surfaces usually have an emission ratio of 0.9. This setting is practical for
many measurement tasks.
94
Settings and the menu item "Temperature measurement" (also see figure on the
Important!
Note the resolution of the display and the limited range of the output. If the
range is chosen to be too large, minimal changes to the temperature
cannot be shown.
Also note that temperatures outside of the defined range are not shown.
Measurements
SONOCHEK 09.2018
Advertisement
Table of Contents
