Table of Contents
Advertisement
SONOCHEK
4.1.8
Creating a folder for measurements
Measurement data in the device can be structured for later evaluation via the grouping of
measurements in folders and their unique labeling. It is absolutely recommended to select a
unique name to make it possible to assign individual recordings to the measurement location
later as well.
The following labels are possible:
Name of the system, the hall or the work area: (abbreviations are recommended if possible on
account of the limited number of characters of 40)
Label of the measured object (compressed air system, condensate drain)
After every restart of the app, the display above the spectrogram shows
*No active folder.*
To create a new folder:
1. Tap on the
The input window for the folder name is opened and the
label "Folder X" is selected as per the factory setting.
2. Use the keyboard to enter a new name (maximum of 40 characters, no special characters)
and confirm the entries with "Next."
The folder label is overwritten and the input field for notes is activated.
3. Store additional information here, which is important to you to document the planned
measurements.
4. Hide the keyboard with the
"Save."
The created folder is shown in the folder overview and is marked as
86
Important!
Note:
Recordings can only be started if the storage location (a folder) has been
determined.
These folders are automatically consecutively numbered if you do not
specify a different name.
Special characters are not permitted in folder names.
The measurements of a folder are always combined for the report.
"Folder" icon and the panel "Create new folder."
Important!
Notes / comments for the folder can also be supplemented later in the
folder overview via the
icon and confirm your entries with
icon.
Measurements
active
SONOCHEK 09.2018
Advertisement
Table of Contents
