SM3000
Multipoint Videographic Recorder
6.6.1 Recording Channel Setup
•1 If this parameter is changed from any previous setting other than 'None', a new internal data file for this recording channel is
created. All historical data stored internally for this channel is lost. If this parameter is changed from a previous setting of 'None'
new internal data files for all enabled recording channels are created. Any unarchived data is lost.
IM/SM3000–EN Rev. L
Select the signal source for the selected channel. This can be
1
any external analog or digital signal – Refer to Appendix A, page
129 for full list.
Note.
The input source for Channel 1 in any process group
be an analog input to ensure correct operation of the
recorder.
The tabs change according to the selection made.
Analog Source
Digital Source
Setting a channel source to 'None' does not switch off the
analog input to which the channel was assigned
previously – i.e. the analog input continues to be
monitored. To switch off an analog input, set Analog I/P
'Type' for the required channel to 'Off' – see Section 6.6.2,
page 89.
The trace color cannot be changed. The trace colors are:
1st
2nd
Magenta
Red
Black
7th
8th
Dark
Yellow
Cyan
Yellow
6 Configuration
3rd
4th
5th
Green
Blue
9th
10th
11th
Light
Dark
Green
Cyan
must
6th
Brown
12th
Dark
Magenta
87