Configuring The Digital Indicator View - ABB SM3000 User Manual

SM3000
Multipoint Videographic Recorder

6.5.5 Configuring the Digital Indicator View

Short Channel Tag
Current Value
Units
Alarm Status
Note. Displayed only if the totalizer is enabled for that channel (see Section 6.6.5, page 98) and for display (see below).
IM/SM3000–EN Rev. L
Channel Units
Totalizer Units – see
Totalizer Value – see
Set to 'On' to enable the operator to display the Digital Indicator
view.
Set to 'On' to add the channel totalizer value and units to the
indicator displays (if the totalizer for that channel is enabled –
see Section 6.6.5, page 98).
Select the menu items to be accessible from the Digital Indicator
view.
Message select enable
Enables the Operator to activate one of 24 pre-configured
messages or a user-defined message.
Alarm acknowledge enable
Enables the Operator to acknowledge any alarms associated
with the current group.
Totalizer reset enable
Enables the Operator to reset the totalizer value to the preset
totalizer value on any or all channels.
Totalizer stop/go enable
Enables the Operator to start and stop the totalizer.
Channel select enable
Enables the Operator to display or hide individual channels.
Note. Menu items that are not enabled are greyed-out in the
Digital Indicator View menu.
6 Configuration
below
Note
below
Note
83