SM3000
Multipoint Videographic Recorder
Note. The Internal Security Switch is used to access the Configuration level when 'Configuration security type' is set to 'Internal
switch protected' – see Section 6.4.2, page 65. Do Not use the switch to access the Configuration level when 'Configuration
security type' is set to 'Password protected' (default setting) unless the Password has been forgotten. The switch overrides
Password protection, enabling free access to the Configuration level.
Withdraw the instrument
3
from the case
Fig. 6.2 Setting the Security Switch
Note. The red switch is for factory use only. Ensure it remains in the position closest to the rear of the instrument.
IM/SM3000–EN Rev. L
Remove tamper-proof
1
seal (if fitted)
Red Switch
(see
below)
Note
Switch off the power to
2
the instrument and unscrew
the jacking screw securing
the instrument to the case
Set the yellow Security switch to the
4
'Configuration Level Not Protected' position
Configuration Level Protected
Configuration Level Not Protected
Refit the instrument to the case
5
and secure with the jacking screw
Re-apply power and wait for
6
the Operator level to display
Access the Configuration level as
7
shown in Fig. 6.1, page 52
6 Configuration
53