Configuration; Introduction; Configuration Level Security; Configuration Level Access - ABB SM3000 User Manual

SM3000
Multipoint Videographic Recorder

6 Configuration

6.1 Introduction

This section details the configuration of the instrument locally
using the front panel membrane switches. A configuration file
can also be created on a PC and transferred to the instrument
via one of the archive media options.
In addition, up to 5 different configurations can be stored in
internal memory and restored when required.

6.1.1 Configuration Level Security

Two methods of configuration access protection are available:
1. Password protection (Factory Default).
The Configuration level cannot be accessed until the
correct password has been entered – see Fig. 6.1, page
52.
2. Internal switch protection.
The Configuration level cannot be accessed until the
instrument is withdrawn from its case and the internal
switch set to the 'Configuration Level Not Protected'
position – see Fig. 6.2, page 53.
Internal Security Switch
Setting
(see Fig. 6.2, page 53)
Configuration Level
Protected
(Factory Default)
Configuration Level Not
Protected
6.1.2 Configuration Level Access – Figs. 6.1 and 6.2
To configure an instrument when 'Configuration security type' is
set to the factory default setting of 'Password protected':

Access the Configuration Level – see Fig. 6.1, page 52.

Make changes to parameters as detailed in Figs. 6.1
and 6.3.
To configure an instrument when 'Configuration security type' is
set to 'Internal switch protected':

Set the internal security switch to the 'Configuration Level
Not Protected' position – see Fig. 6.2, page 53.

Access the Configuration Level – see Fig. 6.1, page 52.

Make changes to parameters as detailed in Figs. 6.1
and 6.3.
IM/SM3000–EN Rev. L
'Configuration security type'
Parameter Setting
(see Section 6.4.2, page 65)
'Password 'Internal switch
protected' protected'
(Factory Default) (Alternative)
Password Access No Access
Free Access Free Access
6 Configuration
51