Digital Input Configuration - ABB SM3000 User Manual

SM3000
Multipoint Videographic Recorder

6.6.3 Digital Input Configuration

Note. The 'Digital I/P' tab is displayed only if 'Source ID' for the Recording Channel is set to a digital signal source – see
Section 6.6.1, page 87.
•1 If this parameter is changed, a new internal data file for this recording channel is created. All historical data stored internally for
this channel is lost.
92
Note. This parameter is displayed only if a standard analog
•1
input module is fitted and 'Input type' on the 'Analog I/P' tab is
set to 'Volt free digital input'. If this parameter is changed to
anything other than 'Volt free digital input', the input channel
reverts to an analog input channel – see Section 6.6.2, page 89.
Enter the tag to be displayed on channel indicators when the
•1
digital signal is active (6 characters max.).
Note. Tags with a high percentage of capital letters and wide
characters such as 'W' or 'M' may appear truncated in some
Operator views. In such cases, use lower case letters or fewer
characters.
Enter the tag to be displayed on channel indicators when the
•1
digital signal is inactive (6 characters max.).
Enter the tag name to be displayed on channel indicators and
•1
used to identify the channel in archive files (8 characters max.).
Note. Tags with a high percentage of capital letters and wide
characters such as 'W' or 'M' may appear truncated in some
Operator views. In such cases, use lower case letters or fewer
characters.
Enter the tag name to be displayed in the Process view and
•1
used in the archive files (20 characters max.).
6 Configuration
IM/SM3000–EN Rev. L