Front Lower A-Arm Removal; Front Lower A-Arm Installation - Polaris RANGER XP 900 2018-2019 Service Manual

STEERING / SUSPENSION

FRONT LOWER A-ARM REMOVAL

1. Properly lift and support the vehicle by the frame.
2. Remove the four wheel nuts and remove the wheel.
3. Using a socket and open-end wrench, remove the
lower ball joint pinch bolt (A) at the bearing carrier.
4. Using a socket and open-end wrench, remove the
two fasteners retaining the lower A-arm to the frame.
5. Remove the lower A-arm from the vehicle.
WARNING
Upon A-arm installation completion, test vehicle at low
speeds before putting into service.
8.16

FRONT LOWER A-ARM INSTALLATION

The locking agent on the existing bolts was destroyed
during removal. DO NOT reuse old hardware. Serious
injury or death could result if fasteners come loose
during operation.
1. Install the lower A-arm onto the frame. Torque the
new lower A-arm fasteners to specification.
Lower A-Arm Fasteners:
40 lb-ft (54 Nm)
2. Install the lower A-arm ball joint into the bearing
carrier. Torque the new fastener to specification.
Ball Joint Pinch Bolts:
42 lb-ft (57 Nm)
3. Install wheel and torque wheel nuts to specification.
Wheel Nuts (Steel): 60 lb-ft (81 Nm)
Wheel Nuts (Aluminum): 120 lb-ft (163 Nm)
Upon A-arm installation completion, test vehicle at low
speeds before putting into service.
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
DANGER
TORQUE
TORQUE
TORQUE
WARNING
© Copyright Polaris Industries Inc.