Upper And Lower Rear Control Arm Removal/Installation - Polaris Hawkeye Repair Manual

BODY AND STEERING

UPPER AND LOWER REAR CONTROL ARM REMOVAL/INSTALLATION

Described in this section is for one side of the machine. Duplicate this process for the other side.
1. Raise and secure the rear of the machine.
2. Remove the rear wheel.
3. Remove the rear shock.
4. Remove the Upper Control Arm (UCA) (15) fasteners (1,4,12) from the transmission and bearing carrier. Note the long (12,14)
and short (1,3) fasteners and pivot shaft locations.
5. Remove the x short grey bushings (2) and pivot shafts (3,14).
6. Remove the Lower Control Arm (LCA) (11) fasteners (4,5,12) from the frame and bearing carrier. Note the long (5,8) and
short (12,14) fasteners and pivot shaft locations.
7. Remove the long grey bushings (9) and pivot shaft (8) from the frame.
8. Remove the short bushings (13) and pivot shaft (14) from the bearing carrier.
9. Remove the LCA (11) from the unit.
10. Replace in reverse order with the following torque values.
• LCA to Bearing Carrier 40 ft-lb (54Nm)
• LCA to Frame 40 ft-lb (54Nm)
• UCA to Bearing Carrier 40 ft-lb (54Nm)
• UCA to Transmission 40 ft-lb (54Nm)
• Shock Mounts (top and bottom) 40 ft-lb (54Nm)
• Wheel Lug Nuts 27 ft-lb (37Nm)
5.16
- www.instant-manuals.com -