Headlight Housing Removal; Headlight Housing Installation - Polaris RANGER XP 900 2018-2019 Service Manual

ELECTRICAL
6. Install the harness onto the new headlight bulb and
install the hood.

HEADLIGHT HOUSING REMOVAL

1. Remove the hood from the front cab.
2. Remove the Torx-head screw
retaining the upper right portion of the front fender.
3. Carefully lift up the front fender far enough to access
the entire headlight housing.
4. Disconnect the harness from the bulb. Refer to
"Headlight Bulb
procedure.
5. Remove the O-rings from each side of the headlight
housing.
6. Remove the adjustment screw.
7. Carefully push on the face of the headlight housing
to disengage the housing tabs from the front fascia
brackets.
8. Remove the headlight housing from the vehicle.
11.22
q
and push rivet
Replacement"page 11.21

HEADLIGHT HOUSING INSTALLATION

1. Install the headlight housing by pressing the housing
tabs back into the front fascia brackets.
2. Secure the headlight housing with the rubber O-rings
on each side. Install the adjustment screw.
w
Be sure to twist the O-rings upon installation as shown
3. Connect the harness to the bulb.
4. Install the Torx-head screw
retaining the upper right portion of the front fender.
5. Install the hood.
6. Adjust headlights
Adjustment" procedure.
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
NOTICE
below.
q
and push rivet
using the "Headlight
© Copyright Polaris Industries Inc.
w