Polaris RANGER XP 900 2018-2019 Service Manual page 370

Table of Contents

Advertisement

FINAL DRIVE
9. Install armature plate
plate tabs are fully engaged into the roll cage
assembly and that it is resting properly on the torsion
spring retainer.
NOTICE
Verify armature plate tabs are in the roll cage slots and
that it rests properly on the spring retainer.
10. Carefully install the ring gear and roll cage assembly
i
into the gearcase housing.
11. Install a new O-ring on the cover plate assembly.
NOTICE
Be sure the square O-ring is placed flat on the cover
surface. If the O-ring is twisted fluid leakage may occur.
7.22
u
. Be sure all of the armature
12. Carefully install the LH output hub assembly
the cover plate. Take care not to damage the new
cover plate seal while installing the output hub.
13. Install the output cover assembly
gearcase housing. Install the seven cover plate
s
screws
and torque to specification.
Front Gearcase Cover Plate Screws:
7–11 lb-ft (10–15 Nm)
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
a
onto the
TORQUE
© Copyright Polaris Industries Inc.
o
into

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ranger xp 1000 2018-2019Ranger crew 900 2018-2019Ranger crew 1000 2018-2019

Table of Contents