Installing The Tn2312Bp Ipsi Adapter - Avaya G650 Installing

Installing and cabling the G650 Media Gateway
EMI gaskets provide electromagnetic interference to or from the TDM cable with the outside
environment. You must install the EMI gaskets before you put cabinets B, C, D, or E in the rack.
To install the EMI gaskets:
1. Peel the paper backing from the gasket
2. Locate the unpainted outlined area on top of the G650 Media Gateway
3. With the gasket opening facing the rear of the rack, place the gasket on the:
a. Right top for G650 A and C
b. Left top for G650 B and D
After you put the last G650 in the rack:
1. Cable the rack (see
2. Install the TN2312BP IPSI adapter (proceed to
page 28).

Installing the TN2312BP IPSI adapter

Figure 8: G650 IPSI adapter
To install the TN2312BP IPSI adapter:
1. Install the TN2312BP IPSI adapter on the connector panel in position 1 for carrier A.
2. If you use duplicated IPSIs, connect another IPSI adapter in position 1 for carrier B.
3. To connect the G650 to the Ethernet, connect the CAT 5 Ethernet cable to the adapter.
4. If you want to use the external alarm function, attach a 9-pin external alarm cable to the
TN2312BP IPSI adapter. For the unterminated end, see the job aid titled Connector and
Cable Diagrams (Pinout Charts) (555-245-773).
28 Installing the Avaya G650 Media Gateway
Cabling the G650 Media Gateways
shows the TN2312BP IPSI adapter.
on page 40).
Installing the TN2312BP IPSI adapter on