3. Note any circuit packs for which the VINTAGE column shows NO BOARD or CONFLICT.
The letter u indicates unassigned ports, and a number indicates that the port was
translated.
Testing the TN2312BP IPSl circuit pack
To test the TN2312BP Internet Protocol Server Interface (IPSI) circuit pack with Avaya Site
Administration:
Type test ipserver-interface UUC and press Enter to test all clock and packet
●
interface components within the IPSI circuit pack
Testing bearer duplication with the TN2602AP circuit pack
To verify that calls are being processed with the TN2602AP circuit packs:
1. Make an external trunk call to a telephone on the port network and leave the call active.
2. Type status media-processor board UUCSS, where UUCSS is the location of the
active circuit pack.
The Media Processor Status screen appears.
3. Look at the LINKS and DSP CHANNEL STATUS categories to determine whether the call is
being processed.
4. Type set media-processor UUCSS, where UUCSS is the location of the standby
TN2602AP circuit pack.
The standby TN2602AP circuit pack becomes active.
5. Type status media-processor board UUCSS, where UUCSS is the location of the
newly active circuit pack.
The Media Processor Status screen appears. Under DSP CHANNEL STATUS, the test call
has moved to the column for the newly active TN2602AP circuit pack.
Testing the TN2312BP IPSl circuit pack
Issue 2 February 2007
59