Battery Removal
1. Remove the driver's seat to access the battery.
2. Disconnect the black (negative) battery cable.
3. Disconnect the red (positive) battery cable.
4. Remove the hold-down strap and lift the battery out
of the vehicle.
CAUTION
To reduce the chance of sparks: Whenever removing
the battery, disconnect the black (negative) cable first.
When reinstalling the battery, install the black (negative)
cable last.
Battery Installation
IMPORTANT: Using a new battery that has not been
fully charged can damage the battery and result in a
shorter life. It can also hinder vehicle performance.
Follow the battery charging procedure in Chapter 10
"Electrical" before installing the battery.
1. Ensure the battery is fully charged.
2. Place the battery in the battery holder and secure
3. Coat the terminals with dielectric grease or
4. Connect and tighten the red (positive) cable first.
5. Connect and tighten the black (negative) cable last.
6. Verify that cables are properly routed and reinstall
Battery Off Season Storage
Refer to Chapter 10 "Electrical" for off season storage
procedures.
Battery Charging (Maintenance Free)
Refer to Chapter 10 "Electrical" for charging procedure.
Spark Plug Service
1. Remove the rear service panel:
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
MAINTENANCE
with hold-down strap.
petroleum jelly.
the driver's seat.
• RZR / RZR S: Remove the driver and passenger
seats.
• RZR 4: Remove both rear passenger seats.
2
2.29