Battery; Battery Removal; Battery Installation - Polaris RZR 900 2015 Service Manual

Table of Contents

BATTERY

1. Remove the driver's seat to access the battery

Battery is located under left rear seat on RZR 4 900.

2. Disconnect the black (negative) battery cable.

To reduce the chance of sparks: Whenever removing

the battery, disconnect the black (negative) cable first.

When reinstalling the battery, install the black (negative)

3. Disconnect the red (positive) battery cable.

4. Remove the battery hold-down bracket

5. Lift the battery out of the vehicle.

9926814 R08 -

Using a new battery that has not been fully charged can

damage the battery and result in a shorter life. It can

also hinder vehicle performance. Refer to Battery

Charging, page 2.35 before installing the battery.

1. Ensure the battery is fully charged.

2. Place the battery in the battery holder and secure

with hold-down bracket. Torque bracket fastener to

specification.

3. Coat the terminals with dielectric grease or petroleum

4. Connect and tighten the red (positive) cable (s) first.

Torque fasteners to specification.

5. Connect and tighten the black (negative) cable (s)

6. Verify that cables are properly routed and reinstall the

driver's seat.

2015-2016 RZR 900

Battery Hold-Down Bracket:

8 ft-lb (11 Nm)

Battery Terminal Fasteners:

60 in-lb (7 Nm)

2016 RZR S 1000 Service

Table of Contents