Polaris RZR 800 2013 Manual page 245

8. Depress reservoir cap and remove retaining ring
from the reservoir.
9. Remove the reservoir cap.
10. Install the Bearing Cap Removal Tool (commercially
available) around shock body.
11. Place a retaining ring (A) in the groove between the
body and the cap.
12. Tap tool upward with a rubber mallet to release and
remove bearing cap.
BODY / STEERING / SUSPENSION
13. Press downward on the bearing assembly (B) to
14. Install the Shock IFP Tool (2871351) onto the IFP
15. Push downward on the IFP tool while pulling upward
16. Remove the center screw and O-ring from the IFP.
17. Remove the IFP using the Shock IFP Tool
18. Remove shock body assembly from the vise. Drain
19. Secure the shock rod in a vice using the shock rod
20. Using a 3/4" wrench, remove and discard the lock
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
expose the retaining ring (C). Remove the retaining
ring from the shock body.
located in the reservoir.
on the shock shaft to remove the shock shaft
assembly.
(2871351).
and properly dispose of shock oil.
holding tool (2872429). Position the shock rod so the
threaded end is facing upward.
nut from the end of shock rod.
IMPORTANT: Keep the
compression valve stacks in the order they were
removed. If unsure of order, refer to "Shock
Valving" under the "Shock Service Information"
provided earlier in this section.
5
rebound and
5.55