Polaris RZR 800 2013 Manual page 402

TRANSMISSION
16. Install the park flange and torque the (5) screws to
specification.
Park Flange Screws:
130-155 in-lbs (15-18 Nm)
17. Install the reverse clutch assembly onto the park
flange. Note the orientation of the needle bearing.
18. Install the retaining plate and a new retaining ring.
8.22
19. Install the input shaft seal and verify it is fully seated.
Install the intermediate shaft seal (circled) flush or
slightly below the case. Apply lubricant to both seal
lips.
20. Place the transmission shift housing onto a flat
surface as shown. Apply a bead of crankcase
sealant onto the mating surfaces. Align the dowels
and install the transmission case half onto the shift
housing while rotating the input shaft, using care not
to damage the seal surfaces.
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
Apply Sealant: PN 2871557
to Case Mating Surfaces