Rear Bearing Carrier; Bearing Carrier Inspection / Removal - Polaris RZR 800 2013 Manual

REAR BEARING CARRIER

Bearing Carrier Inspection / Removal

1. Elevate rear of vehicle and safely support machine
under the frame area.
CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. Wear eye protection when removing
bearings and seals.
2. Check bearings for side play by grasping the top and
bottom of the tire firmly and checking for movement.
The tire should rotate smoothly without binding or
rough spots.
3. Remove the (4) wheel nuts and remove rear wheel.
4. Remove the cotter pin and loosen the rear wheel hub
castle nut. Remove the nut, and (2) cone washers
from the rear wheel hub assembly.
5. Remove the two brake caliper mounting bolts.
6. Remove the rear wheel hub assembly.
7. Remove the bolts that attach the rear bearing carrier
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
CAUTION: Do not hang caliper by the brake line.
Use wire to hang caliper to prevent damage to brake
line.
to the upper and lower A-arms.
FINAL DRIVE
7
7.31