Polaris RZR 800 2013 Manual page 259

10. Replace the o-ring on the piston valve and lubricate
with low temperature grease. Install the piston valve
as follows:
• This is the COMPRESSION side of the piston
valve (Fig. 17). When installed, the compression
side FACES the compression valve stack.
• The bleed shim tabs are centered in the middle of
the compression ports (Fig. 18).
BODY / STEERING / SUSPENSION
11. Install the piston valve as shown in the photo (Fig
12. Install the rebound valve stack onto the shock shaft.
13. Replace the IFP o-ring. Apply a thin layer of low
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
• Note the orientation of the bleed shim tabs as the
assembly would be installed on the shock shaft
(Fig. 19).
20). Install the lock nut and torque to specification.
Keep the bleed shim tab aligned with the piston valve
when tightening the lock nut.
Tighten the lock nut to specification.
NOTE: Verify the bleed valve shim tab is
orientated correctly with the piston valve when
tightening lock nut.
Shock Shaft Lock Nut:
22 ft-lbs (30 Nm)
temperature grease to the IFP.
5
5.69