Rear Drive Shaft; Drive Shaft Removal - Polaris RZR 800 2013 Manual

6. Torque wheel hub nut to 80 ft-lbs (108 Nm) and
install a NEW cotter pin. Tighten nut slightly if
necessary to align cotter pin holes.
Wheel Hub Castle Nut:
80 ft-lbs (108 Nm)
7. Install wheel and (4) wheel nuts. Torque wheel nuts
to specification.
Wheel Nuts:
Steel Wheels: 27 ft-lbs (37 Nm)
Aluminum Wheels: 30 ft-lbs + 90° (1/4 turn)
8. Rotate wheel and check for smooth operation. Bend
both ends of cotter pin around end of spindle in
different directions.

REAR DRIVE SHAFT

Drive Shaft Removal

1. Elevate rear of vehicle and safely support machine
sure machine is secure before beginning this service
2. Remove the (4) wheel nuts and remove rear wheel.
3. Remove the cotter pin and loosen the rear wheel hub
4. Remove the two brake caliper mounting bolts.
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
under the frame area.
CAUTION
Serious injury may result if machine tips or falls. Be
procedure. Wear eye protection when removing
bearings and seals.
castle nut. Remove the nut, and (2) cone washers
from the rear wheel hub assembly.
CAUTION: Do not hang the caliper by the brake line.
Use wire to hang caliper to prevent damage to the
brake line.
FINAL DRIVE
7
7.35