List Of Error Codes Without Messages - Canon Color imageRUNNER C2880i Sending And Facsimile Manual

List of Error Codes without Messages

If an error occurs while a document is being sent or received, an error code is
displayed on the job log in the System Monitor screen, and is included in various
reports. Check what the error code is, and then take the required steps to solve the
problem. (See "Report and List Samples," on p. 14-2, and Chapter 9, "Checking/
Changing the Send/Receive Status.")
NOTE
# 001
Cause 1
Remedy
Cause 2
Remedy
Cause 3
Remedy
# 003
Cause
Remedy 1 Reduce the resolution or divide the document into two or more parts, and then
Remedy 2 When receiving a document, ask the remote party to either reduce the
13
# 005
Cause 1
Remedy
Cause 2
Remedy
13-14
Error Messages
If a send job is canceled, <STOP> is printed in the Results column on the Send report.
Originals are jammed in the paper supply opening of the feeder.
Check the originals and scan settings, and then try scanning again.
Different sized originals were scanned without setting the Different Size
Originals mode.
Set the Different Size Originals mode, and then try scanning again.
Different sized originals were scanned in the 2-Sided Original without setting
the Different Size Originals mode.
Set the Different Size Originals mode, and then try scanning again.
Communications that take longer than the preset time (64 minutes) caused the
error.
try sending the document again. (See "Resolution," on p. 3-12.)
resolution at which the document is scanned, or divide the document into two or
more parts before sending it.
The recipient did not answer within 35 seconds.
Confirm that the recipient's machine is able to communicate, and then try again.
The receiving machine is not a G3 fax.
Check the type of machine that the recipient has.