Using A Server - Canon Color imageRUNNER C2880i Sending And Facsimile Manual

Using a Server

You can specify a destination by searching the directory listings on the network
using LDAP (Lightweight Directory Access Protocol) servers. LDAP servers are for
looking up a particular piece of information, such as a user name, e-mail address,
or other contact information.
NOTE
•
You may have to set up the LDAP servers beforehand, depending on the network
environment.
•
For more information on LDAP servers, see "Addresses Obtained via a Server," on
p. 10-23.
•
You can send to a maximum of 64 destinations at the same time, including destinations
that are specified via a server.
•
The information that can be obtained via the LDAP server consists of only names and
e-mail addresses. If the optional Super G3 FAX Board or Super G3 Multi-Line Fax Board
is installed, fax numbers, in addition to the above mentioned information, can be also
obtained via the LDAP server.
•
You cannot directly specify a destination that is obtained via a server as a forwarding
destination. To specify the destination as a forwarding destination, you must first store it
in the Address Book. (See "Addresses Obtained via a Server," on p. 10-23.)
1
Press [Network Add.Book].
2
Press the Server to Search drop-down list ➞ select the desired
server to search.
Specifying Registered Destinations
2
2-27