Canon Color imageRUNNER C2880i Sending And Facsimile Manual page 392

No response from the server. Check the settings.
Cause
Remedy
NetWare is in use. Wait for a moment, then perform operation again.
Cause
Remedy
There are too many subdirectories.
Cause
Remedy
No response.
Cause 1
Remedy
Cause 2
Remedy
Cause 3
Remedy
Cause 4
Remedy
13
Check the TCP/IP.
Cause
Remedy
13-10
Error Messages
The specified server settings are incorrect, or the server is not turned ON.
Alternatively, the machine's TCP/IP resources may be low.
Wait for a while, and then try browsing again. If there is still no response from
the server, try selecting another server.
You cannot browse the network because NetWare is printing through a PServer
or NDS PServer.
Wait until printing is complete, and then try browsing again.
You have exceeded the maximum number of subdirectory levels allowed.
Specify a different destination because the directory level that you are trying to
access cannot be specified.
The server was not running when you tried to send.
Make sure that the server is ON, and check the destination.
The network connection was lost when you tried to send. (Either you could not
connect to the destination, or the connection was lost before the job could be
completed.)
Check the status of the network.
You tried to send via NetWare, but the Tree name was not entered.
Enter the Tree name.
A TCP/IP error occurred when you tried to send an e-mail message or I-fax.
Check that the network cables and connectors are properly connected.
The machine's TCP/IP connection is not operating.
Check the IP Address Settings (IP Address, DHCP, RARP, BOOTP) in TCP/IP
Settings in Network Settings in System Settings (from the Additional Functions
screen). (See Chapter 3, "Using a TCP/IP Network," in the Network Guide.)