Installation Guide
Figure 42: Drive Layout
Step 3 : Now that the drives are installed into the chassis, test the installation by sliding the enclosure
in and out of the rack a minimum of three times. If the enclosure binds, catches, or displays any
incorrect motion or behavior retry the installation of the drives and chassis.
W hat to do next: T he drives are now installed. Proceed to
5.7.1 Operating the 2.5" Drive Carrier
Follow these steps to operate the clamping mechanism and install a 2.5" drive in the carrier.
Step 1 : Locate the release clips on the rear and press them inward to release the clamp.
Caution: To ensure proper airflow for enclosure cooling, all drive slots must be
populated with either drives or drive blanks.
Shipping Screws Installation (page
5. Installation
5.7 Drive Installation
73).
71