Table of Contents
Advertisement
Installation Guide
5.4 CMA Installation
This procedure provides instructions for installing the cable management assembly for an Ultrastar
Serv60+8 .
Before you begin: Complete the instructions in
Table 36: Installation Requirements
Tool(s): N/A
Part(s):
Person(s): 1
Time: 10 minutes
Step 1 : Install the crossbar onto the CMA mounting bracket.
a. Align the crossbar with the mounting peg facing down and pointing toward the CMA
mounting bracket.
b. Insert the peg on the underside of the crossbar into the slot on the CMA mounting bracket.
c. Swing the crossbar so that the thumbscrew lines up with the mounting hole on the opposite
side of the enclosure.
d. Press the crossbar against the CMA mounting bracket and secure the crossbar in place by
pressing and turning the thumbscrew clockwise until snug.
a. Check that the crossbar is fully secured to the CMA mounting bracket by pulling on the bar
to ensure it does not move.
Step 2 : Install the CMA(s).
a. Orient the CMA so that the elbow is on the left hand side.
b. Attach all three of the connectors to the brackets on the rails. There should be one at the
elbow side and two at the other end.
CMA Standard Arm 1EX1174 (single)
CMA Lite Arm 1EX1834 (2U baskets) or 1EX1602 (1U baskets)
Note: CMA has one arm, to be installed at the lower position. This arm should have
the elbow on the left side.
Chassis Installation (page
5. Installation
5.4 CMA Installation
57).
61
Advertisement
Table of Contents
