Table of Contents
Advertisement
Installation Guide
Figure 16: Inner Rail Attachment
c. Slide the inner rail toward the rear of the chassis to lock it in place. There will be an audible
click and the mounting pegs will cover the front part of the keyhole.
Figure 17: Slide Inner Rail
d.
Install the three special low-profile M4 x 3.2mm Philips screws provided to secure the inner
rail to the chassis.
e. Follow these steps for the second inner rail on the opposite side of the enclosure.
Step 3 : Set the vertical rack rail depth to between 32" and 36".
Caution: When installing the inner rail onto the chassis, make sure to only use
the special Low-Profile M4 x 3.2mm Philips screws provided in the accessory
kit with the CMA. These screws should be tightened to .90-1.12 Nm / 8-10 in-
lbf using a # 2 Philips Screwdriver. These screws are specially designed for this
purpose. Using unapproved screws could cause damage to the slides inside
the rail.
Note: Ensure that all of the vertical rails are set to the same depth using a tape
measure.
5. Installation
5.2 Rails Installation
48
Advertisement
Table of Contents
