Table of Contents
Advertisement
Installation Guide
Specification
Typical Power Consumption
PSU Connector Type
Inrush Current Maximum (per
Inrush Current Typical (per PSU)
Caution: The Ultrastar Serv60+8 can only be plugged into high line (200 - 240 VAC) power. If
the unit is plugged into low line (110-127 VAC), the PSU will report a "Critical" state when status
pages are queried using SES. In this case, the enclosure will power up, but the drives will not.
1.5 Mechanical Specifications
Table 4: Mechanical Specifications
Specification
Enclosure Dimensions
Length of Enclosure w/
Required Rack Width
Required Rack Depth
Rack Units (U)
Vertical Rack Rail
1.6 Performance Specifications
1.
Max and typical power consumption values represent the output power to the system. Input power will vary depending
on the PSU efficiency and load sharing between PSUs.
1
Input Voltage
PSU Efficiency
PSU)
Non-Operational
Shock
10G, 0 - peak,11ms half sine;
3 positive and 3 negative
pulses in each axis shock
Vibration
0.75G, 0 - peak swept sine;
5 -500Hz; 1 complete sweep
@ 1/2 octave per minute
Weight
W: 447mm x L: 1030mm x H: 175mm / W: 17.6in. x L: 40.6in. x H: 6.89in.
CMA
450mm (17.72in.) minimum width with 465mm (18.31in.) ± 1.5mm nominal
hole spacing and W1 is 492mm minimum. See EIA-310 Rack Standard
1200 mm (47.24in.) of usable rack space, frame to frame
Spacing
Value
~1800W
200 - 240 VAC
C14
80 PLUS Platinum
AC line inrush current shall not exceed 35A peak
measured per IPC-9592B(L) Appendix C-4.1.
15A
5G, 0 - peak, 11ms half sine; 3 positive
and 3 negative pulses in each axis-
minimum 6 seconds between shocks
to allow for write/read recovery
0.10G,0 - peak swept sine; 5 -500Hz;
1 complete sweep @ 1/2octave per
minute
95.25 kg / 210 lbs.
CMA Standard: 1182mm / 46.5in.
CMA Lite: 1148mm / 45.2in.
4U
812.8mm - 914.4mm / 32 in. - 36 in.
1. Overview
1.5 Mechanical Specifications
Operational
6
Advertisement
Table of Contents
