Table of Contents
Advertisement
Installation Guide
Figure 39: Chassis Handle Operation
Step 4 : Perform this same action two more times without the drives loaded to make sure the rail kits are
installed properly.
W hat to do next: T he top cover is now installed, and extension of the enclosure for servicing has been
tested. Proceed to
5.7 Drive Installation
This procedure provides instructions for installing drives in an Ultrastar Serv60+8 .
Before you begin: Complete the instructions in
Table 41: Installation Requirements
Tool(s): Long T15 Torx Screwdriver
Part(s): 3.5in HDD Assembly and/or 2.5in SSD Assembly
Person(s): 1
Time: 30 minutes
Step 1 : Install the 3.5in HDD Assembly.
a. Ensure that the enclosure has been pulled out of the rack until the rail latches engage.
b. Find the LED pointer on the top of the drive carrier. This pointer should point toward the
front of the unit as shown in the following image.
Drive Installation (page
68).
Note: The 2.5in SSD Assembly is installed in the same manner as the 3.5in HDD
Assembly. For instructions on assembling the 2.5in SSD Assembly, see
the 2.5" Drive Carrier (page
Top Cover Installation and Extension Test (page
71).
5. Installation
5.7 Drive Installation
66).
Operating
68
Advertisement
Table of Contents
