Operating The 2.5" Drive Carrier - Western Digital Ultrastar Data60 Installation Manual

Installation Guide
5.8.1 Operating the 2.5" Drive Carrier
Follow these steps to operate the clamping mechanism and install a 2.5" drive in the carrier.
Locate the release clips on the rear and press them inward to release the clamp.
Step 1 :
Figure 54: Clamp Release (clamp shown in blue for visual clarity)
Step 2 : Slide the clamp in the direction shown in the following image to loosen it from the drive. Be sure
not to slide too far as this will allow the clamp to fall from the carrier body and it will have to be
reinstalled.
Figure 55: Clamp Slide (clamp shown in blue for visual clarity)
Insert the 2.5" drive into the drive slot so that it is snug into the corner.
Step 3 :
5. Installation
5.8 Drive Installation
66