Table of Contents
Advertisement
Installation Guide
Figure 23: Rack Spacer Nut Plate Installation
c. Using a T15 Torx screwdriver, tighten the top captive screw to secure the mounting plate in
place. Tighten the remaining captive screws at the bottom of the spacer bracket, and torque
all four of the captive screws to 3.38-3.61 Nm / 30-32 in-lbf.
Figure 24: Captive Screws
d. Repeat these steps to install the remaining rack spacer.
Step 6 : Install the rear cover alignment brackets and secure the rear rails.
5. Installation
5.2 Rails Installation
53
Advertisement
Table of Contents
