Äapplying Effects To Output Audio - Roland V-160HD Reference Manual

Audio Operations
Applying Reverb
This adds reverberation to the sound.
* Reverb is not applied to the audio from the AUX bus.
Adjusting how much reverb to send
Ó
1 .
[MENU] button "AUDIO INPUT"
"SDI IN 8," and press the [VALUE] knob.
2 .
Use the [VALUE] knob to select "REVERB SEND," and press
the [VALUE] knob.
3 .
Use the [VALUE] knob to adjust the amount of sound that
is sent to reverb (reverb depth).
4 .
Press the [MENU] button to close the menu.
Adjusting how much reverb is returned
Ó
1 .
[MENU] button "AUDIO OUTPUT"
Ó
select "REVERB," and press the [VALUE] knob.
2 .
Use the [VALUE] knob to select "ON," and press the
[VALUE] knob.
Reverb turns on.
3 .
Use the [VALUE] knob to select "LEVEL," "TYPE," or "SIZE,"
and press the [VALUE] knob.
Menu item Explanation
Specifies the amount of sound that is returned from the
LEVEL
reverb (return level). This adjusts the depth of the overall
reverb.
Specifies the reverb type.
ROOM: Produces the natural-sounding reverberation of
TYPE
a room.
HALL: Produces the reverberation that is typical of a
performance in a concert hall.
Specifies the size of the room. The larger the value, the
SIZE
longer the reverb time.
4 .
Use the [VALUE] knob to change the value of the setting,
and press the [VALUE] knob.
5 .
Press the [MENU] button to close the menu.
MEMO
You can assign the function to a USER button and turn reverb on/
off (p. 65).
42
Ó
select "AUDIO IN 1"–
Ó
"MASTER OUTPUT"
Applying Effects to Output Audio
Here's how to modify the tonal character by applying effects.
The following table shows the effects that are available.
Reverb Equalizer
Audio bus
µ µ
MASTER
OUTPUT
AUX — —
Ó
1 .
[MENU] button "AUDIO OUTPUT"
OUTPUT" or "AUX," and press the [VALUE] knob.
2 .
Using the [VALUE] knob, select the menu item of the
effect you want to use, and press the [VALUE] knob.
* For details on the menu items, refer to "10: AUDIO OUTPUT"
(p. 88).
3 .
Use the [VALUE] knob to change the value of the setting,
and press the [VALUE] knob.
4 .
Press the [MENU] button to close the menu.
ÁEqualizer
This is a three-band equalizer. It lets you adjust the volume by
boosting or cutting three frequency regions.
ÁDelay
a delay. Delaying the output lets you correct
Outputs audio with
timing problems in the audio signal that is input to the output
destination device.
ÁMulti-band compressor
Applies separate compressors in individual frequency band.
ÁLimiter
Limits the output volume so that is does not exceed the specified
threshold level.
* Distortion will occur if audio that exceeds the allowable range of
the limiter is input.
MEMO
Adjusting the equalizer/delay for the USB output audio
For USB output, you can also apply equalizer and delay effects to
fine-tune the sound assigned to the bus.
Adjust the equalizer and delay parameters from the [MENU]
Ó
button "AUDIO OUTPUT"
Multi-band
Delay
compressor
µ µ
µ
—
Ó
select "MASTER
Ó
"USB OUT. "
Limiter
µ
µ