Applying Effects To Output Audio - Roland V-1SDI Owner's Manual

Audio Operations

Applying Effects to Output Audio

This applies effects and adjusts the sound quality for
output audio.
1.
Display the AUDIO menu (p. 12), then select the
effect menu item you want to use.
* For more information about effects, refer to the following
section.
2.
Use the A/B fader to adjust the setting value.
3.
Quit the menu (p. 12).
Equalizer (EQ)
This adjusts the sound quality for each frequency band.
MASTER OUT (page 12/15)
Menu item Explanation
EQ Hi This boosts or attenuates the high band.
This adjusts the center frequency when
EQ Hi FREQ
changing the sound quality in the high band.
EQ Mid This boosts or attenuates the middle band.
This adjusts the center frequency when
EQ Mid FREQ
changing the sound quality in the middle band.
This adjusts the width of the frequency band
EQ Mid Q
when boosting or attenuating the middle band.
EQ Lo This boosts or attenuates the low band.
This adjusts the center frequency when
EQ Lo FREQ
changing the sound quality in the low band.
Mastering (MASTERING)
This adjusts the acoustic characteristics and tone
quality.
MASTER OUT (page 15/15)
Menu item Explanation
MASTERING This switches mastering on and off.
This adjusts the degree of application of the
NS
noise suppressor.
This adjusts the degree of application of the
ENHANCER
enhancer.
This suppresses high-frequency distortion and
Hi
adjusts the sound to have sustained tones.
This suppresses midrange distortion and
Mid
adjusts the sound to have distinct tones.
This suppresses low-frequency distortion and
Lo
adjusts the sound to have stable tones.
28
Reverb (REVERB)
This adds lingering reverberations to the audio.
You can apply reverb to audio input via AUDIO IN,
MIC, SDI IN, and HDMI IN.
MASTER OUT (page 13/15)
Menu item Explanation
This adjusts the return level from reverb
LEVEL of the audio. A setting of "0" results in no
reverb applied.
TIME This adjusts the length of the reverb.
This specifies the type of reverb.
ROOM: Produces the natural reverberations
of a highly resonant room.
TYPE
HALL:
Produces reverberations like that of
a performance in a concert hall or
other such space.
1.
Display the AUDIO menu (p. 12), then select the
input audio where you want to apply reverb
using "REVERB SEND LEVEL."
2.
Use the A/B fader to adjust the amount of audio
sent to reverb.
Repeat steps 1 and 2 as needed to individually
adjust the amount of reverb applied.
3.
At the AUDIO menu, select "LEVEL" under
REVERB.
4.
Use the A/B fader to adjust the amount of audio
returned from reverb.
This adjusts the depth of overall reverb applied
while maintaining the balance in the degree
of reverb applied to the individual input audio
streams.
5.
Quit the menu (p. 12).