Applying Effects To Output Audio - Roland XS-62S Owner's Manual

Audio Operations

Applying Effects to Output Audio

This applies effects and adjusts the tone quality for master out
and AUX-bus audio.
* Only the limiter can be used on AUX-bus audio (p. 26).
Select the [MENU] button 0 "AUDIO OUTPUT" 0
1.
"MASTER OUT," "PVW," or "AUX."
2.
Select an effect menu item, then use the [VALUE]
knob to adjust it.
* For more information about effects, refer to the following
section.
3.
Press the [VALUE] knob to apply the setting.
4.
Press the [MENU] button to quit the menu.
28
Equalizer (EQ)
This adjusts the tone quality for each frequency band.
Menu item Explanation
EQ Hi This boosts or attenuates the high band.
This adjusts the center frequency when
EQ Hi FREQ
changing the tone quality in the high band.
EQ Mid This boosts or attenuates the middle band.
This adjusts the center frequency when
EQ Mid FREQ
changing the tone quality in the middle band.
This adjusts the width of the frequency band
EQ Mid Q
when boosting or attenuating the middle
band.
EQ Lo This boosts or attenuates the low band.
This adjusts the center frequency when
EQ Lo FREQ
changing the tone quality in the low band.
Multi-band compressor
(MULTI BAND COMP)
This applies separate compressors in individual frequency bands.
Menu item Explanation
This switches the multi-band compressor
MB COMP
on and off.
These set the individual levels that become
MB COMP H THLD
the thresholds for the high, midrange,
MB COMP M THLD and low bands at which the compressor is
applied. Compression is applied to audio
MB COMP L THLD
that exceeds the threshold.
These set the amount of compression
MB COMP H RATIO
applied in the high, midrange, and low
MB COMP M RATIO
bands. The state in which no compression
MB COMP L RATIO
is applied is defined as "1. "
Limiter (LIMITER)
This compresses audio input that is too high, thereby preventing
distortion.
Menu item Explanation
LIMITER This sets the limiter on or off.
This sets the level that becomes the threshold
at which the limiter is applied.
Compression is applied to audio that exceeds
LIMITER THLD
the threshold. The volume level of audio that
is output is limited so as to stay to below the
threshold.
* PGM/1, PVW/2 bus only
* PGM/1, PVW/2 bus only