J Right Hand Unit Lift/Lower Switch; K Centre Unit Lift/Lower Switch - Ransomes Highway 3 Safety, Operation & Maintenance Manual

6 CONTROLS
NOTE: THE OPERATOR MUST BE SEATED TO ENABLE LIFT / LOWER FUNCTIONS.
6.2J RIGHT HAND UNIT LIFT/LOWER SWITCH ____________________________
To lower the cutting unit move the switch
lever forward.
To raise the cutting unit move the switch lever
rearwards
NOTE:
If the PTO is engaged when the unit is
lowered the green led will illuminate when the
unit is below 400mm from the ground.
The yellow PTO LED will illuminate when the
reel is rotating.
If the lever is pulled momentarily rearwards
the unit will raise to the cross cut position and
continue to rotate for 3 seconds. Lowering
the unit within 3 seconds will let the reel continue
rotating without stopping.
If the lever is held and the unit lifts above the cross cut position the unit will continue to lift and the
reel will stop rotating at 400mm. The lift will stop when the lever is released.
6.2K CENTRE UNIT LIFT/LOWER SWITCH ________________________________
To lower the cutting unit move the switch lever forward.
To raise the cutting unit move the switch lever rearwards
NOTE:
If the PTO is engaged when the unit is
lowered the green led will illuminate when the
unit is below 400mm from the ground.
The yellow PTO LED will illuminate when the
reel is rotating.
If the lever is pulled momentarily rearwards
the unit will raise to the cross cut position and
continue to rotate for 3 seconds. Lowering
the unit within 3 seconds will let the reel
continue rotating without stopping.
If the lever is held and the unit lifts above the cross cut position the unit will continue to lift and the
reel will stop rotating at 400mm. The lift will stop when the lever is released.
en-36