Lubrication - Grizzly G0935 Owner's Manual

Lubrication

This machine has numerous moving metal-to-
metal contacts that require regular and proper
lubrication to ensure efficient and long-lasting
operation, and to protect your investment.
Other than the lubrication points covered in this
section, all other bearings are internally lubricated
and sealed at the factory. Simply leave them
alone unless they need to be replaced.
Before performing
DISCONNECT MACHINE FROM POWER!
Table and Column Ways
Lube Type ............. SB1365 or ISO 68 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ........8 Hours of Operation
Items Needed
Shop Rags ......................................... As Needed
Mineral Spirits .................................... As Needed
SB1365 or ISO 68 Equivalent ............ As Needed
Move way covers out of the way and clean X-, Y-,
and Z-axis ways (see Figures 54–56) with rags
and mineral spirits to remove grime and old lubri-
cation. Wipe ways with recommended lubrication,
then move components back and forth several
times over full range of travel to spread lubricant
and ensure smooth movement.
Z-Axis
Way Cover
Z-Axis
Way
Figure 54. Location of Z-axis way cover and
ways.
Model G0935 (Mfd. Since 04/21)
any lubrication task,
Qty
Z-Axis
Leadscrew
Z-Axis
Way
Y-Axis Way
Y-Axis
Way Cover
Figure 55. Location of Y-axis way cover and
ways.
X-Axis Way
X-Axis
Leadscrew
Figure 56. Location of X-axis ways.
Leadscrews
Lube Type ............. SB1365 or ISO 68 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ......40 Hours of Operation
Items Needed
Stiff Brushes ...................................................... 2
Mineral Spirits .................................... As Needed
SB1365 or ISO 68 Equivalent ............ As Needed
Move way covers out of the way and clean X- , Y-
and Z-axis leadscrews (see Figures 54–56) with
brush and mineral spirits to remove grime and old
lubrication. Use clean brush to wipe leadscrew
teeth with recommended lubrication, then move
components back and forth several times over
full range of travel to spread lubricant and ensure
smooth movement.
Y-Axis
Leadscrew
Y-Axis Way
X-Axis Way
Qty
-37-