Grizzly G0935 Owner's Manual page 34

3. Loosen (4) cap screws shown in Figure 38 to
release belt tension.
Figure 38. Location of belt tension cap screws.
4.
Refer to belt configuration chart shown in
Figure 39 to configure belts on pulleys for
selected spindle speed range.
LOW
Spindle Pulley
LOW: 80–1700 RPM
HIGH
Spindle Pulley
HIGH: 280–5000 RPM
Figure 39. Belt configuration chart.
IMPORTANT: Model G0935 ships with high
speed range belt installed. Belt for low speed
range is smaller than high speed range belt
and has teeth to engage upper pulleys. Only
one belt should be installed at a time, and
belt must be installed on correct pulleys.
— If either belt is worn or damaged, replace.
-32-
x 4
Motor Pulley
Motor Pulley
5. After belt is properly positioned on pulleys,
use tension bolt shaft shown in Figure 40 to
push motor pulley away from spindle pulley
and engage belt tension.
Spindle
Pulley
Figure 40. Applying belt tension.
6.
Tension belt until there is approximately
of belt deflection when you apply moder-
ate pressure on belt with your finger (see
Figure 41).
— If belt cannot be tensioned correctly, belt is
worn and needs to be replaced.
Approximately
/ " Deflection
1
4
Spindle
Pulley
Figure 41. Correct belt deflection.
7.
When belt has been tensioned correctly,
tighten (4) cap screws loosened in Step 3 to
secure.
8.
Install headstock cover and secure with flat
washers and headstock cover lock knob.
Model G0935 (Mfd. Since 04/21)
Tension
Bolt Shaft
Motor
Pulley
⁄ "
1
4
Motor
Pulley