Grizzly G0935 Owner's Manual page 48

5. Lift entire spindle motor assembly out of
headstock (see Figure 66).
Brush Cap
(1 of 2)
Figure 66. Location of spindle motor brush caps.
6. Remove brush caps and worn brushes from
motor (see Figure 67).
Brush
(1 of 2)
Brush Cap
(1 of 2)
Figure 67. Location of brushes under brush
caps.
7.
Replace both spindle motor brushes and
install brush caps.
8.
Install spindle motor.
9. Install belt (refer to Setting Spindle Speed
on Page 31).
10. Install headstock cover.
Replacing Power Feed Motor Brushes
Items Needed
Phillips Head Screwdriver #2 ............................ 1
Penny or Dime ................................................... 1
Replacement Brush Pair (P0935353-3) ............ 1
-46-
To replace power feed motor brushes:
1. DISCONNECT MACHINE FROM POWER!
2. Remove (9) Phillips head screws to open
power feed side and bottom covers (see
Figure 68).
Side
Cover
x 9
Figure 68. Location of power feed covers.
3.
Remove brush caps and worn brushes from
motor (see Figure 69). See Figure 67 for an
example of how motor brushes fit into motor.
Note: It may be easier to access brush cap
on other side of motor with motor removed
from power feed box. To remove motor,
remove (4) screws shown in Figure 69.
Brush Cap
Figure 69. Location of power feed motor brush
4.
Replace both power feed motor brushes and
install brush caps.
Qty
5.
Install power feed motor (if removed).
6.
Install power feed side and bottom covers.
Bottom
Cover
x 4
(1 of 2)
caps.
Model G0935 (Mfd. Since 04/21)