Verify Lubrication; Test Run - Grizzly G0808 Owner's Manual

19. Mount handwheel with pre-installed folding
handle to right end of X-axis leadscrew (see
Figure 28), and tighten set screw on base of
handwheel to secure it (see Figure 29).
20. Mount a remaining handwheel to Y-axis
leadscrew (see Figure 28), and tighten set
screw on base of handwheel (see Figure 29).
21. Thread screw of revolving handle assembly
into handwheel from Step 19, then tighten
jam nut against handwheel to secure handle
(see Figure 28).
Jam
Nut
Figure 28. Table handwheels installed.
Figure 29. Set screw on base of handwheel
(Y-axis shown).
-22-
Handwheel
w/Folding
Handle
Y-Axis
Handwheel
Revolving
Handle
Assembly
Screw
Set Screw

Verify Lubrication

GEARBOX MUST
BE FILLED WITH OIL!
OIL MAY NOT BE
SHIPPED WITH MACHINE!
Refer to Lubrication Section
for Correct Oil Type.
This machine was shipped from the factory with
oil in it, but the headstock oil reservoir level must
be verified before the machine can be operated
for the first time. Refer to the Lubrication sec-
tion, beginning on Page 39, for details on how to
check oil.
Damage caused by running the mill without
oil in the reservoir will not be covered under
warranty.

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
Model G0808 (Mfd. Since 11/15)