Lubrication - Grizzly G0795Z Owner's Manual

Lubrication

This mill/drill requires regular lubrication to main-
tain smooth movement and ensure long-lasting
operation. Components not covered in this sec-
tion are sealed and internally lubricated for life.
Before performing
DISCONNECT MACHINE FROM POWER!
Lubrication Frequency
Lubrication Task
Ball Oilers
Table Leadscrew
Headstock
Column Nut & Bevel Gear
Quill Outside Surface
Quill Rack & Pinion
Table & Column Ways
Headstock
Lube Type ..Grizzly T23962 or ISO 68 Equivalent
Lube Amount ............................................. 1
Check/Add Frequency ........... 8 hrs. of Operation
Change Frequency ................................ Annually
The headstock has the proper amount of oil when
the sight glass shown in Figure 48 is halfway full.
Follow federal, state, and local require-
ments for proper disposal of used oil.
Tools Needed
Wrench 24mm ................................................... 1
Hex Wrench 6mm .............................................. 1
Drain Pan (1 Gallon or larger) ........................... 1
Funnel ................................................................ 1
To change headstock oil:
1.
Run spindle at 600 RPM for approximately 10
minutes to warm oil.
2.
DISCONNECT MACHINE FROM POWER!
-34-
any lubrication task,
Frequency Page
35
Daily
Daily 36
Annually 34
37
Annually
36
Daily
Annually 37
35
Daily
⁄ qt.
1
4
Qty
3. Unlatch and open motor cover.
4. Remove oil fill plug (see Figure 48).
Oil Fill Plug
Figure 48. Headstock oil fill plug and sight glass.
5. Place a 1-gallon or larger drain pan on table
under headstock.
6. Remove drain plug (see Figure 49) and allow
oil to drain into pan.
Figure 49. Location of headstock drain plug
(headstock tilted 90° for clarity).
7.
Replace drain plug.
8.
Place funnel in oil fill hole. Add oil until sight
glass is halfway full (see Figure 48).
9.
Replace oil fill plug and close motor cover.
10. Clean up any spilled oil to reduce slipping
hazards.
Model G0795Z (Mfd. Since 06/17)
Oil Sight
Glass
Drain
Plug