Table of Contents
Advertisement
Quill Outside Surface
Lube Type ............. SB1365 or ISO 68 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ........8 Hours of Operation
Items Needed
Shop Rags ......................................... As Needed
Mineral Spirits .................................... As Needed
SB1365 or ISO 68 Equivalent ............ As Needed
To lubricate quill outside surface:
1.
Fully lower quill and lock in position.
2.
Without disturbing grease on quill rack, clean
outside smooth surface of quill with mineral
spirits and shop rags (see Figure 57).
Quill
Outside
Surface
Figure 57. Quill lubrication area.
3.
When dry, apply thin coat of ISO 68 or
equivalent oil to smooth surface, then move
spindle up and down to evenly distribute oil.
Quill Rack
Lube Type ............. T26419 or NLGI#2 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency .....................6–12 Months
Items Needed
Shop Rags ......................................... As Needed
Mineral Spirits .................................... As Needed
Stiff Brush .......................................................... 2
T26419 or NLGI#2 Equivalent ........... As Needed
To lubricate quill rack:
1.
Lower quill to gain full access to quill rack
(see Figure 57). Lock in position.
-38-
2.
Clean teeth with mineral spirits, shop rags,
and brush.
3.
When dry, use clean brush to apply thin coat
of grease to teeth and raise/lower quill sev-
eral times to evenly distribute.
Qty
Note: Re-apply oil that may have been
removed during the cleaning process to the
smooth quill surface around the rack (refer to
Quill Outside Surface lubrication section).
Replacing Spindle
Depth DRO Battery
If the spindle depth DRO stops operating correct-
ly, the 3V lithium cell battery must be replaced.
Item Needed
Battery LR44 3V ................................................ 1
To replace DRO battery:
Quill
Rack
1.
Slide battery cover to right to expose battery,
as shown in Figure 58.
Figure 58. Battery cover for spindle depth DRO.
Qty
2.
Remove old battery, dispose of it according
to state and federal regulations, then replace
it with a new one.
3.
Replace battery cover.
Model G0935 (Mfd. Since 04/21)
Qty
Battery
Cover
Advertisement
Table of Contents
