Grizzly G0935 Owner's Manual page 24

18. Turn speed control dial (see Figure 19) all
the way counterclockwise to prevent high-
speed startup.
19. Move direction switch to neutral (middle)
position (see Figure 19).
20. Turn leadscrew selector knob (see Figure
19) counterclockwise to disengage power
feed drive gear.
Direction
Speed
Switch
Control Dial
Fault Indicator
Light
Figure 19. Power feed controls.
21. Connect power feed to power by inserting
power cord into a matching receptacle.
During power feed opera-
tion,
handle will spin rapidly if
it is pressed in or acciden-
tally engaged. Always stay
clear of handle when using
power feed. Failure to do so
could lead to entanglement
or impact injuries.
22. Loosen X-axis table lock on front of table
(see Figure 20).
-22-
Leadscrew
Selector Knob
X-axis handwheel
Table
Table Lock
Limit Stop
(1 of 2)
Limit
Switch
Figure 20. X-axis table lock, table limit stops,
and limit switch.
23. Turn leadscrew selector knob clockwise to
engage power feed drive gear.
24. Move direction switch to left position.
25. Turn speed control dial clockwise to turn
power feed ON, then gradually increase
speed to confirm that table is moving to left.
26. Watch for table limit stop to hit limit switch (see
Figure 20). When it hits, fault indicator light
should illuminate (see Figure 19) and motor
should stop. If power feed does not stop, turn
speed control dial all the way counterclock-
wise and move direction switch to middle
(OFF) position.
— If fault indicator light illuminates and power
feed stops, power feed limit switch is
working correctly. Proceed to Step 27.
— If fault indicator does not illuminate, or
power feed does not stop, fault indicator
light or power feed limit switch is not work-
ing correctly. Immediately turn machine
OFF and disconnect power. Contact Tech
Support before continuing with Test Run.
27. Turn speed control dial all the way counter-
clockwise to correct fault mode.
28. Flip direction switch through neutral (middle)
position and all the way to the right. Turn
speed control dial clockwise to turn power
feed ON. Table should begin moving to the
right.
Model G0935 (Mfd. Since 04/21)
X-Axis