Grizzly G0935 Owner's Manual page 44

Power Feed
Symptom Possible Cause
Power feed 1. Power feed not plugged in.
does not move
2. Table locked.
table or slips.
3. Leadscrew selector knob is not engaging
drive gear.
4. Power feed fault light is illuminated.
5. Direction switch in center position.
6. Speed control dial set to '0'.
7. Limit stop is engaging X-axis limit switch.
8. Gears not meshing/teeth missing.
9. Motor shaft and gear shaft not engaged.
10. Wiring broken, disconnected, or corroded.
11. X-axis limit switch is at fault.
Speed will not 1. Speed dial stripped.
adjust or is
2. Wiring broken, disconnected, or corroded.
inconsistent.
3. Potentiometer at fault.
-42-
Possible Solution
1. Plug in power feed (Page 19).
2. Loosen table lock handles (Page 27).
3. Use leadscrew selector knob to engage drive gear
(Page 27).
4. Clear any obstruction then turn speed control dial fully
counterclockwise to clear fault.
5. Toggle direction switch to desired direction of table
travel (Page 27).
6. Turn speed control dial clockwise to increase travel
speed (Page 27).
7. Adjust limit stop (Page 27).
8. Check gears and adjust/replace.
9. Replace clutch.
10. Fix broken wires or disconnected/corroded
connections.
11. Replace limit switch.
1. Replace dial.
2. Fix broken wires or disconnected/corroded
connections.
3. Test/replace potentiometer.
Model G0935 (Mfd. Since 04/21)