Table of Contents
Advertisement
Headstock Controls
L
Figure 3. Z-axis controls.
L.
Z-Axis Lock Handle: Tighten to lock head-
stock in position.
M. Z-Axis Controls: Moves headstock up or
down.
N. Quill Lock Screw: Use with supplied quill
lock hex wrench to secure quill in place for
increased stability during operations.
U
T
S
Figure 4. Spindle depth and headstock controls.
O. Fine Downfeed Knob: Manually controls
rate of fine spindle downfeed.
P. Coarse Downfeed Handle: Pull down for
fast spindle downfeed with drilling operations;
features spring-loaded spindle return.
Q. Downfeed
Selector
to engage fine spindle control for milling
operations.
Model G0935 (Mfd. Since 04/21)
M
N
P
O
Q
R
Handle:
Rotate
R. ZERO Button: Press to zero Spindle Depth
DRO anywhere along its travel.
S. Spindle Depth DRO OFF/ON Button: Press to
turn Spindle Depth DRO display ON and OFF.
T.
mm/inch Button: Press to toggle Spindle
Depth DRO between inches and millimeters.
U. Spindle Depth DRO: Displays spindle travel
and depth.
X-Axis Power Feed Controls
V
W
Z
Y
Figure 5. Power feed controls.
V. Direction Switch: Moves table left and right.
Center toggle position stops power feed
motor.
W. Power Indicator: Glows green when power
feed is connected to power supply.
X. Speed Control Dial: Rotate to turn power
feed ON and OFF. Varies power feed motor
speed from 0–240 RPM.
Y. Leadscrew Selector Knob: Rotate to
engage or release power feed drive gear.
Z.
Fault Indicator: Illuminates when power
feed encounters fault or when power feed
limit switch is activated. Reset by turning
speed control dial to 0.
X
-5-
Advertisement
Table of Contents
