Grizzly G0935 Owner's Manual page 32

To remove tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Unscrew drawbar cap to remove (see
Figure 33).
Note: There is a hole in top of the drawbar
cap to allow access to drawbar and to per-
form the following steps without removing
cap.
Figure 33. Location of drawbar cap.
3.
Use hex wrench in top of drawbar and spindle
spanner wrench in holes in bottom of spindle
to loosen drawbar (see Figure 34).
Top of
Drawbar
Spindle
Spanner
Wrench
Figure 34. Using hex wrench and spindle
spanner wrench to loosen drawbar.
-30-
DO NOT completely unscrew drawbar before
striking it with hammer in following step.
You will damage threads on drawbar and
arbor.
4.
Drawbar
Cap
Figure 35. Example of using hammer to loosen
5.
Installing Tooling
Tools Needed
Hex Wrenches 3, 8mm ................................1 Ea.
Spindle Spanner Wrench .................................. 1
To install tooling:
1.
2.
Spindle
3.
Holes
4.
Tap top of drawbar with brass-head or dead-
blow hammer to unseat taper, as shown in
Figure 35.
drawbar.
Hold onto tooling with one hand and fully
unthread drawbar with other hand.
DISCONNECT MACHINE FROM POWER!
Clean debris or oily substances from inside
spindle taper and tooling mating surface.
Align keyway of tool arbor with protruding pin
inside spindle taper, and firmly push arbor
into spindle to seat it.
With one hand holding tool in place, insert
drawbar into spindle from top of headstock,
then thread it into tool by hand until snug.
Model G0935 (Mfd. Since 04/21)
Drawbar
Qty